JTAG PANTEC PDF

Pantech Solutions. Online Retail store for Trainer Kits,Lab equipment’s,Electronic components,Sensors and open source hardware. This process is to assist in the repair of your Pantec receiver. There are 2 We need to Build a JTAG cable and we need to modify the receiver. To modify the. have performed the JTAG operation on my Pansat A using both Skymax and jKeys .. The first thing to do here is figure out if you have a PanTec MX or MS.

Author: Mikalkree Dokus
Country: Norway
Language: English (Spanish)
Genre: Automotive
Published (Last): 26 January 2007
Pages: 414
PDF File Size: 13.39 Mb
ePub File Size: 12.32 Mb
ISBN: 368-1-44537-738-1
Downloads: 85435
Price: Free* [*Free Regsitration Required]
Uploader: Mauzshura

PANTEC MS REPAIR

Pin Mapping Step 2: Once completed turn off the receiver. Parts you will need: To make this easy we can cheat. This is used to add full control of the CPU for writing. Gently rest the resister end on top of one solder pad on the board.

The cathode of the pqntec goes to ground.

Power up the unit and confirm that it still turns on and goes beyond the night rider stage. Configure Evaluation Board Step 4: Analog Sensor Conditioning Additional content planned Next load the factory bin.

  BUSCOPAN SIMPLES GOTAS BULA PDF

Which jtag is best for pantec mx

Then we apply the auto roll flash by serial interface. A solder tab is not soldered with out the part in this style of manufacture, therefore I believe that the part was accidentally omitted. None of this is really my work but I’m putting it on this site to help you.

Most of these boards are robotically created. You can cut the rest. Locate the following tabs on your receiver If your machine is a MX go here. The solder tabs on the board are already tinned and ready for the mod.

Allow the process to complete. Choose the new bin file from your favorite source. You will be able to solder from the points indicated in the board and run the wires to the jtay. The next part is the ground for the resister. Remember to avoid touching the resister mod and don’t let the grey cable interfere with it.

When your satisfied that the parts are in the right spot, Push the leds into their appropriate holes in the case. If the receiver lights up then all is well. Make sure its firm then leave it alone. Next you want to add the fan. Visualize where you have to put the resister using the photo below.

  CONFISSO DE WESTMINSTER PDF

For the MS problem that may have been shutdown by the flashing of the unit with any flash above auto-roll bin file read on. Note the IRD number is the order in the list Make sure you heat shrink the resister. Configure the Camera and Related Modules Step 5: Do not attempt to drill new holes.

Do not attempt to fasten the assembly to the main board with glues or screws. Once completed the receiver will reboot and you will have only night rider lights. If you get one from a