Find the user manual and the help you need for the products you own at ManualsOnline. I got an old laptop model MA2 without powersupply. SetIP command to see and change the IP addresses of the console. This command can be used to change both Ethernet connectors and even set a gateway. Requirement: STP (shielded twisted pair) cable with RJ45 connector, min. Cat 5e . To connect Ethernet port 1: Connect one end of an Ethernet cable to the.

Author: Majas Goltit
Country: Brunei Darussalam
Language: English (Spanish)
Genre: Spiritual
Published (Last): 10 May 2005
Pages: 148
PDF File Size: 5.74 Mb
ePub File Size: 13.83 Mb
ISBN: 688-5-53449-677-1
Downloads: 81990
Price: Free* [*Free Regsitration Required]
Uploader: Shakar

Naturally the laptop will not boot with ram removed. Janual, create an account now. That’s why laptops seem such a breeze to fix. Mayo Hardware Mon Jul 16, Mayo Hardware Sun Feb 07, Mason Man Wed Jun 23, I’m trying to picture this in my mind. I currently have run into a ma3 that is slightly different then the ma7.

bateway Not sure what the four flashes are, maybe the battery is shorted I have repaired 4 ma7’s with this method. This is because I have not had experience on every motherboard that is out there.


Sorry, I don’t keep records of part numbers and where they are bought. Mayo Hardware Sun Jan 16, I’ll attempt to re-create the same test here.

I had a job once doing hybrid IC’s. Recall of the original problem. Select different version – latest – 3.

I think my problem is the number IV. Thanks again for your time. The outlet working fine good ground, checked the power supply getting DC, ok lets check the continuity.

Will run tests and report back. Each console have two IP addresses – one for each Ethernet connector on the back. Ken Mon Aug 16, Im getting continuity at diode and ao oh the problem is my ma3 only works with the battery, it’s not charging or working from dcjack the dc jack was also replaced.

I can’t seem to figure out what is wrong with this gateway ma2

And I was only taught to do it the right way. Update Me Mon Feb 14, Then type the new IP address – and reboot. Mayo Hardware Wed Jun 16, When shorted, it will read near zero in both directions.

Gatewqy you gave no description of your problem I cannot guess where your problem might be. Did you get a resolution? Windows OS and Software. After assuming it was the dc jack, i re soldered it, without gatsway.


Getting In Too Deep: Gateway MA7/MA3/MA2 – Dead, Won’t Charge

Now it won’t even do that so the customer brought it in. All i make out is the last 2 number The charge light comes on then goes out. Will check my other notes to see if I had documented the last time that happened for me.

Hey Mayo, Just found this post. Operating perfect for 1 hour. Only a member of this blog may post a comment. Other manufacturers and networks specifiers often uses the “10” range for their primary address scheme. Not the chip, that is USB driver.

Neil Wed Jun 23, Check the front center of the DC to the rear for continuity. The only way it works now is if a external monitor is plugged in. Table of contents of this topic hide.