EN 60268-7 PDF

Find the most up-to-date version of CEI EN at Engineering IEC Sound System Equipment – Part 7: Headphones and Earphones is an international standard intended to characterize the. IEC SOUND SYSTEM EQUIPMENT –- PART 7: HEADPHONES AND EARPHONES.

Author: Zulkirg Fenrilabar
Country: Bulgaria
Language: English (Spanish)
Genre: Spiritual
Published (Last): 2 September 2007
Pages: 297
PDF File Size: 13.25 Mb
ePub File Size: 20.53 Mb
ISBN: 200-1-94283-830-5
Downloads: 3578
Price: Free* [*Free Regsitration Required]
Uploader: Midal

This website is best viewed with browser version of up to Microsoft Internet Explorer 8 or Firefox 3. This sequence uses a pink noise stimulus to characterize the passive, active and total attenuation of noise cancelling headphones.

Various pinna couplers used to measure headphone response. The Audio Voice Newsletter.

Headphone Testing (Part 1): The Basics

Setup System, Hardware and Calibration Before attempting to run any of the sequences, read the following setup instructions. Headphones and earphones incorporating corrigendum November It then enters a loop which will run 5 times. Calibrate the Headphone Amplifier channels per the instructions in the SoundCheck manual. Relink dialog Here is a list of sequences and their default signal paths unique paths are in bold: The user is first prompted to enter the rated voltage.

If the 602668-7 is No, the sequence jumps to post-processing steps which calculate passive attenuation and the final display step. In both cases, the test signal is usually a swept sine wave, and the level can vary.

  AFTERSHOCK WIEDEMER PDF

Connect the impedance boxes between the headphone amp out and headphone input.

Sound system equipment – Part 7: Headphones and earphones

Take the smart route to manage medical device compliance. Sound System Equipment — Part 7: In this article, we discuss the issues that are common to testing all types of headphones. Software Requirements SoundCheck Large differences at certain frequencies can be very audible in a stereo device, even though the individual responses may be within specification. Five separate sequences are provided, each designed to measure specific characteristics.

This document Older versions. A test signal is sent to the transducer headphonewhich in turn is measured by a reference microphone in a coupler. The set-up essentially consists of an electroacoustic measurement system, some kind of ear simulator containing a reference microphone, and the device under test. The basic measurements made on headphones are very similar to those made on loudspeakers.

You may experience issues viewing this site in Internet Explorer 9, 10 or Testing on a head-and-torso simulator. In Part 2 we address the specific needs of special cases of headphones such as Bluetooth and USB headphone testing, noise-cancelling headphones, and Max SPL measurements to prevent hearing loss.

  CALDI SOSPIRI PDF

IEC /Cor – Estonian Centre for Standardisation

First, a pink noise stimulus is played from the noise speakers and recorded by the unoccluded ears. You are ready to start the sequence. This approach provides the user with the flexibility to measure all or some of the characteristics of their headphone. The play and record acquisition takes place 3 times and the user is prompted to reposition the DUT on the HATS in between acquisitions.

BS EN – Sound system equipment. Headphones and earphones

Sometimes, electrical characteristics such as crosstalk may also be measured. Some set the drive level to achieve a certain sound pressure level at a given frequency; others choose the level that equates 6026-7 1 mW of power. A series of post-processing steps follow to apply the weighting and correction curves, calculate the LAEQ and then the Simulated Program Characteristic Voltage is calculated along with the Hz voltage sensitivity.

No – I don’t want to receive the latest audio test information by email. Diffuse and free-field correction curves.