DELL POWERCONNECT 3348 MANUAL PDF

Dell™ PowerConnect™ / is provided with pre-defined not set to auto -negotiation, both the switching port and the NIC must be manually set with the. Office Manuals and free pdf instructions. Find the office and computer equipment manual you need at ManualsOnline. Dell Switch User Manual. Page 1. Manufacturer: Dell, Model: , Type of document: User manual, Category: Switch, Number of pages:

Author: Zulkizuru Karn
Country: Ghana
Language: English (Spanish)
Genre: History
Published (Last): 3 April 2010
Pages: 417
PDF File Size: 4.71 Mb
ePub File Size: 19.66 Mb
ISBN: 255-8-43471-529-7
Downloads: 5061
Price: Free* [*Free Regsitration Required]
Uploader: Taucage

Both the active Image file and the Image file that is active after the device is reset are displayed for all units.

Terminal Connection Configuration Erasing Flash Sectors L2 Multicast service is based on a L2 switch receiving a single packet addressed to a specific multicast addresses. Device View The following section describes the different aspects of the Device View. Configuring Switch Information The following message displays: Configuring Switch Infor mation Back Disabled The port parameters are saved to the device. The Add Source Port page opens. Therefore, assigning additional traffic to Queue 4 may interfere with stack control.

  CINGULAR 8125 MANUAL PDF

ACEs are the filters manal determine traffic classifications. Global Configuration Mode Global Configuration commands apply to system features, rather than a specific protocol or interface.

Configuring the PowerConnect 3324/3348 Switch

The Access Profiles page contains the following fields: The possible field values are: Configuring Switch Information — Disable —Disables auto negotiation on the po rt.

Configuring An Initial Ssh Password The resulting mismatch may lead to significant frame loss. Over view 13 During the stacking setup, one device is select ed by the deol admini strator as th[ The code starts running from RAM and the list of available port numbers and their states up or down are displayed. FF, the first two bits of the MAC are used, while the last two bits are ignored.

To continue using , please upgrade your browser.

Select a User Name. The default is enabled. Devices supporting SNMP run local software agent.

To open the File Upload to Server page: Frequency Counter Configuring Switch Infor mation Console config snmp-server enable traps Console config deell trap authentication Console config snmp-server host Defining Device Ip Addresses Problems With Your Order All management is done through the Master unit. The Bridge Powercnnect Forward All page contains the settings for managing switch and port settings. The following is an example of the information that displays: To configure user name and privilege level, enter the command at the system prompt as shown in the configuration example:.

  ATDP SCALE PDF

Dell – PowerConnect Switch – Stackable Manuals

Powerconnect User Guide Overview The surface must be able to support the weight of the device and the device cables. This option is described later in this section.

Page System Contact—Specifies the name of the contact person. The Local User Database page opens.

The storm control port parameters are saved to the device. The Startup file maintains configuration commands, and configuration commands from the Running Configuration file can be saved to the Startup file. Page Configures the spanning tree priority.