Specs ASTM B Alloy OFE OFHC Copper Round Rod. View More · Alloy Copper Rectangle Square Edge. ASTM B – Free download as PDF File .pdf), Text File .txt) or read online for free. C Round OFE SH Copper Products Rod. H04 (hard). 12 Foot Mill Lengths. ASTM B, ASTM F Diameter. (Inches). Diameter. Tolerance. Pounds.

Author: Dolkree Faelkis
Country: Bangladesh
Language: English (Spanish)
Genre: Software
Published (Last): 7 November 2005
Pages: 379
PDF File Size: 2.74 Mb
ePub File Size: 17.99 Mb
ISBN: 582-5-94462-794-8
Downloads: 76980
Price: Free* [*Free Regsitration Required]
Uploader: Shakarg

This term means that a wire 1 m in length and weighing 1 g would have a resistance of 0. Over 1 to 11? The compositions of these alloys are equivalent to C plus the intentional addition of silver.

The approximate Rockwell hardness values for the speci? Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk astk infringement of such rights, are entirely their own responsibility.

Round, Hexagonal, Octagonal—See Table 3. C Light-straightening operation is permitted. B Percent of speci? This specification establishes the requirements for copper conductor bars, rods, and shapes for both electrical bus and general applications.


All sizes 28 [] Rod: The corners, A, will usually be sharp, but shall not have rough or projecting edges. Over 3 [75] 30 [] Bar: E C, C, and C are oxygen-free coppers with the addition of a speci? Products shall be produced in tempers O60 soft annealedand H04 hard. C, C, C, C It is also equivalent, for example, to 1.

Originally approved in Dimensions, Mass, and Permissible Variations The deviation from absolute straightness of any longitudinal surface or edge shall not exceed the limitations prescribed in Table Last previous edition approved in as B — Over 2 to 3 [50 to 75] incl.

ASTM B – 00 Standard Specification for Copper Bar, Bus Bar, Rod, and Shapes

Over 4 [] to 12 [] incl. G Oxygen n187 trace elements may vary depending on the process. A B Width times thickness, disregarding any rounded corner or edges. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

Within the text, the SI units are shown in brackets. The purchaser shall have the right to perform any of the inspections or tests set forth when such inspections and tests are deemed necessary to ensure that the material conforms to prescribed requirements. C, refer to the Annex of Speci?


Shapes shall not include tube and pipe or other hollow sections. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. Limits for unnamed elements may be established and analysis required by agreement between the manufacturer or the supplier and the purchaser.

ASTM B187 Grade C10200 H04 bar

A 2 [50] and Under 0. ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.

The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. The surface is similar in texture to that of the outside surface of an orange. A Tolerances, Plus and Minus,A in.