ALLEN BRADLEY 1305 VFD MANUAL PDF

However, using an Allen-Bradley motor with your drive removes the . Н Installation guidelines called out in Appendix D of the User’s Manual. Installation Instructions IN. May, Allen-Bradley. Dynamic Brake. Cat. No. KAA KBA03, KBA06, KBA Table of Contents. Find great deals for Allen Bradley Adjustable Frequency AC Drive User Manual. Shop with confidence on eBay!.

Author: Mezimi Nill
Country: South Sudan
Language: English (Spanish)
Genre: Technology
Published (Last): 24 July 2017
Pages: 454
PDF File Size: 17.63 Mb
ePub File Size: 16.93 Mb
ISBN: 956-4-58111-131-1
Downloads: 91342
Price: Free* [*Free Regsitration Required]
Uploader: Digami

Allen Bradley Adjustable Frequency AC Drive User Manual | eBay

May occur on nanual. DC Braking cannot be used with a synchronous motor. Phase V Fault – F39 A phase to ground fault has been detected bradly the drive and motor in this phase. Verify that the parameter has been programmed correctly. Change [Cable Length] to “Long” if applicable. Skip frequencies and skip bandwith eliminate all operating frequencies. DC Bus voltage fell below the minimum value. Bus overvoltage can also be caused by motor reeneration. Inspect for proper mounting and spacing.

Check [Minimum Freq] and [Maximum Freq] parameters. Fast repairs at low costs.

Connect proper adapter or change active frequency source. Unplug the HIM from the cable or drive and reconnect it.

Allen Bradley Adjustable Frequency AC Drive AB

Capabilities of drive are different than the master drive. Reset your drive to the factory default settings. Phase U Fault – F38 A phase to ground default has been detected between the drive and motor in this phase.

  CRCP CRYSTAL REPORTS CERTIFIED PROFESSIONAL ALL-IN-ONE PDF

The last parameter programmed alln be displayed on the top line. Check the external potentiometer circuit at TB2, terminals 1, 2, and 3 for a disconnected current. If not, manually program any remaining parameters. Check for proper mounting and spacing.

An external pot is connected and the ground lead of the pot is disconnected, creating a potential drive overspeed hazard. Download can only occur with the same type of drive.

Check motor for grounded phase.

1305 AC Drives

Open Pot Fault – F9 An external pot is connected and the ground lead of the pot is disconnected, creating a potential drive overspeed hazard. An attempt has been made to set the [Run Boost] parameter to a value greater than the [Start Boost] parameter. A longer acceleration tiime or a lighter load may be required. Check for broken wires, loose connections, or transducer loss at mA input, TB2.

Extend the deceleration time or instal dynamic brake option. Error 5 – Drive is running while attempting download Repeat operation.

Verify that all parameters have been programmed. Please select the Repairs tab for more information or to request a quote. Hz Err Fault – F29 No valid operating frequency.

  LANNEA MICROCARPA PDF

Error 2 – The number of parameters in saved profile does not equal master number.

Reprogram Fault – F48 May occur when drive parametersare reset to default settings. Check for external noise sources. Hz Sel Fault – F30 An unconnected adapter has been selected as the active frequency source. Reset to Default Parameters and Cycle power. Inspect for breaks in communications line. Serial Fault – F10 An active local bus adapter is disconnected while it possesses control of a local bus function.

Check for a short circuit at the drive output or excessive load conditions at the motor.

Allen Bradley 1305 Adjustable Frequency AC Drive User Manual

Correct the bradlwy of the fault and manually clear by cycling the stop command or cycling power. Replace the Communication cable. Motor Stall Fault – F6 The motor has stalled If the motor is drawing excessive current, the motor load is excessive and will not allow the drive to accelerate to set speed.